1200W 15KHZ Variable Frequency Ultrasonic Plastic Welding Transducer And Generator For Plastic Welder

Precautions for assembling the transducer of ultrasonic plastic welding machine: Check the contact surfaces. The contact surface shall be flat and smooth without scar. If there is any scar, polish it gently with metallographic sandpaper above zero. It is required to smooth the defects without damaging the flatness…

Send Inquiry

Chat Now

1200W 15KHZ Variable Frequency Ultrasonic Plastic Welding Transducer And Generator For Plastic Welder

Precautions for assembling the transducer of ultrasonic plastic welding machine:

Check the contact surfaces. The contact surface shall be flat and smooth without scar. If there is any scar, polish it gently with metallographic sandpaper above zero. It is required to smooth the defects without damaging the flatness of the contact surface.
Clean. Clean the screws, screw holes and contact surfaces with volatile and non corrosive detergent, and thoroughly clean the screws, screw holes and contact surfaces.
Install. All connecting screw holes shall be perpendicular to the contact surface.
Before tightening, apply a thin layer of butter or Vaseline on the contact surface. Be careful not to apply it on the connecting screws and screw holes.
Carefully tighten the two components. According to the different specifications of connecting screws, control the appropriate tightening torque, and tighten it appropriately if possible.
If the joint surface is loosened again, there should be no scar.
Touch the vibration system with your hand to ensure even amplitude, no strange sound and no local severe heating.
After working for a period of time, the joint surface should be loosened again without oxidation or ablation marks, otherwise it means that the contact here is not good, and the ultrasonic energy is seriously lost here.

Type	Full-length(mm)	Joint Bolt(mm)	Frequency(KHz)	Resonance Impedance(Ω)	Capacity(pF)	Input Power (W)
PLS-HJHNQ152600	153	M20×1.5	15	15	13000	2600
PLS-HJHNQ152000	167	M20×1.5	15	10	9500	2000
PLS-HJHNQ202000	128	M18×1	20	10	11000	2000
PLS-HJHNQ30500	77	M10×1.5	30	5	5500	500
PLS-HJHNQ28200	92.1	M10×1	28	20	3000	200
PLS-HJHNQ28100	91	M8×1	28	25	2200	100
PLS-HJHNQ28250	94	1/2-20 UNF	28	20	4000	250
PLS-HJHNQ202000	128	1/2-20 UNF	20	10	20000	2000
PLS-HJHNQ201500	124	1/2-20 UNF	20	10	16000	1500
PLS-HJHNQ38100	66	M8×1.25	38	40	1200	100
PLS-HJHNQ38200	65	M8×1	38	14	3300	200